Dishwasher Water Supply Through Floor

When enough water has filled the dishwasher the rising float switch is supposed to tell the dishwasher to stop the water flow.

Dishwasher water supply through floor.

Then get on the floor to connect lines to the dishwasher. Grab a towel or mop and soak up any visible water on your floor. This valve can malfunction and fill the dishwasher with water when not in use. Tip the dishwasher upright and slide it into its space.

If you see water in the dishwasher when you are not using it check the water inlet valve for faults. Connect the water supply line to the dishwasher. This will allow the dishwasher to be pulled out during servicing. This might mean pulling the unit out from under the counter so you can get any water that has pooled beneath the dishwasher itself.

The float switch is stuck or broken. Your unit may be taking in more water than it should and not draining properly. Leave about six feet of cable sticking through the hole by the dishwasher. Extend the stainless steel braided water supply hose from the sink cabinet out to the dishwasher.

Adjust the leveling legs with a wrench until the dishwasher is perfectly level. Replace the dishwasher s front panel. Use a drill driver to screw the dishwasher s mounting tabs to the underside of the countertop. 3 drill another 1 inch hole 6 inches below the hole for the hose to feed the copper tubing water supply line at the back of the.

To avoid scratching the floor lift slightly as you pull the dishwasher out of the cabinet. Drill the hole for the dishwasher drain hose at this location. You may be experiencing problems with the drain itself or the float valve isn t sealing properly. Connect the water supply line to the 90 degree fitting using pliers to ensure a tight fit.

Carefully slide the dishwasher into place. The dishwasher is supplied with water from the water inlet valve. Connect the drain hose according to manufacturer s instructions. The moment you notice your dishwasher is or has leaked make sure to first turn off the dishwasher.

This will force water out of your dishwasher and on to your floor. If this valve is faulty the dishwasher can fill with water and overflow onto the floor. Then install 12 awg cable from the dishwasher space to the service panel. Tape the hose down to the floor with electrical tape.

To add a circuit cable drill a hole down through the floor into the basement or crawlspace.